Project Recap: Giving this Vintage Hepplewhite Dresser a Pop of Color

Sharing is caring!

In these quick guides, I walk through the steps I took and the products I used for a particular makeover. Interested in learning more about a particular step or process? Check out the links at the bottom of this post where I go into greater detail on each step.

Steps I used to achieve this look:

  1. Cleaning. I cleaned the exterior of the piece with a degreaser, using these ScotchBrite pads to really scrub off any dirt and grime, then wipe back with a microfiber cloth. I then clean the inside, bottom and back with a mixture of water and Dawn dish soap. Finally I’ll wipe back the piece again with water and a clean microfiber cloth.
  2. Repair work. This piece only needed some minor filling on the top drawer and top. I used All Purpose Bondo for the larger sections and Bondo Glazing and Spot Putty for the smaller dings and scratches. These plastic spreaders are my favorite for applying both of these products.
  3. Scuff sanding. I scuff sanded the entire piece with 220 grit sandpaper using my SurfPrep sander. However, you don’t need a fancy sander to do this step! Hand sanding works fine – you aren’t trying to remove the finish, just scuff up the existing finish to help with primer and paint adhesion.
  4. Prime. This dresser is mahogany veneer, which is very prone to bleeding through water based paints and products. I used a shellac-based primer, BIN, to prime and seal this piece, doing 3 coats and letting the primer cure overnight before painting.
  5. Paint. I painted this dresser in the fun color Golden Hour by Melange Paints with my favorite brush. It is a beautiful muted golden yellow!
  6. Topcoat. I sealed this piece with one of my favorite topcoats, wax finish varnish by Polyvine. I find this to be the easiest waterbased topcoat to apply if you are using a brush. I has a good work time and doesn’t appear cloudy (even on darker colors). I use this brush to apply. The combo of these products gives me a smooth and reliable finish.
  7. Update hardware. I wanted to keep this beautiful vintage brass hardware, so I cleaned it by boiling it in a 50/50 mixture of vinegar and water for 10 minutes, then scrubbed with 0000 grade steel wool and Bar Keepers Friend. This gave a really bright brass finish, so I used a combination of Rub n’ Buff shades (Ebony and European Gold) to give them a more vintage feel.

Want to learn more about each step? Check out the links below:

Disclosure: This post may contain affiliate links, meaning I get a commission if you decide to make a purchase through those links, at no cost to you. I appreciate your support.