Project Recap: MCM Chest of Drawers Painted in Navy

Sharing is caring!

Before photo of MCM three drawer chest of drawers.
Three drawer chest of drawers painted in Navy.

In these quick guides, I walk through the steps I took and the products I used for a particular makeover. Interested in learning more about a particular step or process? Check out the links at the bottom of this post where I go into greater detail on each step.

Steps I used to achieve this look:

  1. Cleaning. I cleaned the exterior of the piece with a degreaser, using these ScotchBrite pads to really scrub off any dirt and grime, then wiped it back with a microfiber cloth. Then I cleaned the interior, bottom, and back with a mixture of water and Dawn dish soap. Finally, I’ll wiped back the piece again with water and a clean microfiber cloth.
  2. Repair work. There was a missing chunk of wood from the middle drawer, but thankfully it had been saved and was in the drawer itself. I used wood glue and clamps to reattach this piece. I also used Bondo to fill a missing chunk on one of the handles and fill some gaps left on the sides from water damage.
  3. Sanding/Scuff Sanding: After allowing the Bondo to dry, I sanded those areas smooth. Next, I scuff sanded the entire piece with 220 grit sandpaper using my SurfPrep sander. However, you don’t need a fancy sander to do this step! Hand sanding works fine – you aren’t trying to remove the finish, just scuff up the existing finish to help with primer and paint adhesion.
  4. Prime. There were a bunch of stains (even after sanding and cleaning) that I wanted to be sure were sealed, so priming this one was a must. I used shellac as a primer.
  5. Paint. I painted this dresser in the color Classic Navy by Melange Paints with my favorite brush.
  6. Topcoat. I sealed this piece with one of my favorite topcoats, General Finishes High-Performance Topcoat in Flat. I use this Zibra brush to apply. The combo of these products gives me a smooth and reliable finish.
  7. Drawers: I added this peel-and-stick wallpaper as a drawer liner and used this slide lubricant to ensure smooth drawer sliding.
  8. Adding Feet: Finally, I wanted to elevate this piece off of the floor just a bit, so I added these feet I found on Etsy.
Close up photo of a dresser drawer with navy polka dot drawer liner.
Close up photo of the foot of a navy dresser.

Want to learn more about each step? Check out the links below:

Disclosure: This post may contain affiliate links, meaning I get a commission if you decide to make a purchase through those links, at no cost to you. I appreciate your support.